You want stronger preparation of CCIE Service Provider Certification written exam in a short time. DumpsSchool updated Cisco 400-201 dumps give knowledge which increases your skills to design, implement, diagnose, and troubleshoot complex Service Provider services.
Which router or router combination is used to calculate the MPLS traffic engineering tunnel path?
Question No. 2
Which three options are restrictions for MPLS VPN BGP Local Convergence? (Choose three.)
Answer: A, D, E
Question No. 3
Which statement about the requirements of eBGP multipath is true?
Question No. 4
What is a limitation of implementing uRPF?
Question No. 5
Refer to the exhibit
Refer to the exhibit. How can IPv4 hosts located on the IPv4 Internet access the IPv6-only servers located in a small IPv6-only net
Question No. 6
In MVPN GRE, what is the limitation for unicast GRE tunnels?
Question No. 7
An operations engineer identifies a device is receiving a section loss signal alarm for a SONET link. Which action does the engineer perform?
Question No. 8
ATM carries IP and PPP information with ATM cells. What ATM adaptation Layer is used when an ATM cell carries IP packets and PPP frames?
Question No. 9
Which two options are characteristics of MoFRR? ( Choose two)
Answer: A, E
Question No. 10
Which three things are the building blocks of the Cisco VPLS architecture? (Choose three)
Answer: C, D, E
Question No. 11
Which three security mechanisms are used to mitigate or protect against DoS attacks that are targeted at a router? (Choose three)
Answer: B, C, F
Question No. 12
According to RFC 3931, L2TPv3 utilizes the IANA assigned IP protocol ID of:
IP Protocol 115 (L2TPv3)
Question No. 13
An engineer is designing a SONET network using Cisco 7600 and the ONS 15454 platform. Which Cisco 7600 module allows for three 45 Mbps serial interfaces?
Question No. 14
A company is using a Layer 2 Frame Relay network. Which circuit emulation will a network engineer use to extend the customer Frame Relay network over the Service Provider backbone?
Question No. 15
In AToM, control word is an optional 4-byte field used in the pseudowire packet. The control word carries generic and Layer 2 payload-specific information to emulate L2 packets correctly. In pseudowire packet, where is this control word inserted?